Black Roof Edge Screws

Step-by-step plan

1. Place the edge trim on the underlay of your roof.
2. Fasten with our Edge Trim Screws 5 cm from the end of the edge trim, then fasten a new screw every 25 cm.
3. Take a straight POLYESTER CONNECTOR and insert it into the vertical section of the next edge trim. Place this next edge trim 2 mm from the previous one.
4. Finally, place the top layer of your roof covering over the edge trim. To ensure a waterproof finish, seal the edge trim under the upper lip with ROOF SEAL MASTIC.
5. How do I use black edge trim with EPDM? Place the edge trim on the EPDM layer of your roof.
6. Fasten with our Black Edge Trim Screws 5 cm from the end of the edge trim, then fasten a new screw every 25 cm. These screws have an EPDM washer, so additional sealing is not necessary.
7. Then take a straight connector piece and place it in the vertical part of your next roof edge profile. Place this next roof edge profile 2 mm from the previous one.
8. To make a corner, you can easily cut two roof edge profiles at a mitre. Use a corner connector to ensure a perfect fit.